Spacing
A general rule of thumb suggests that roses should be planted about
24 inches apart. This spacing will vary depending on the type of
rose you are planting. Old garden roses will need wider spacing,
while miniatures can be planted closer. Sufficient space between
plants allows for good air circulation, an excellent first step
in disease control.
Bare-Root Roses (Packaged Roses)

Bare-root roses should be received as close to planting time as
possible. In northern growing areas, roses can be planted as soon
as soil can be worked in the spring. If the roses arrive early,
check that the packing material is moist and keep them in a cool,
dark place.
Before
planting, soak bare-root roses in a bucket of water for 8-12 hours
to help rehydrate the roots. If the canes are dehydrated, the whole
plant may be immersed in water. After soaking, trim off any damaged
or diseased roots. Botrytis, a grey mold, is a common disease found
on the roots and canes of plants held in storage. In addition to
pruning the roots, they may also be soaked in water to which the
fungicide Daconil has been added.
Try
to maintain 3-5 canes per plant, and each cane should be pruned
back to 3-5 buds per cane. Any cane thinner than a pencil should
be removed. Buds are easy to spot as raised oval areas on the cane.
Roots may need additional pruning to remove damaged portions or
to fit the planting hole.
Planting holes should be dug wide enough and deep enough to comfortably
accept the roots of the plant. Make a cone-shaped mound of soil
in the center of the hole to support the plant, with the bud union
at soil level. Fill the hole about 2/3 full of soil and add water,
making a slurry of soil that gets between the roots. Do not tamp
the soil, as this compacts it and destroys soil structure. After
the water has drained down, add more soil and repeat the water fill
process until the original soil level has been reached. Since the
soil is loose, the plant will sink a little after planting, the
bud union will end up 1-2 inches below soil level. This is where
the bud union should be for roses growing in northern climates because
this helps to provide some winter protection for the bud union.
|

Bare root rose planting procedure |
The canes of dormant, newly planted bare-root roses need to be
protected from drying winds and handled to encourage maximum bud
break. To accomplish this, a temporary soil mound is placed over
the canes to a depth of about 8-10 inches. This process is called
"sweating" and is done to keep the canes moist to encourage
maximum bud break. The soil is left in place for about 2-3 weeks
or until new growth starts. When new growth does start, gently wash
away the soil with a hose so as not to disturb the new growth. Other
methods that works well are to wrap the canes in burlap that is
kept moist or to mound the canes in sphagnum moss. Some rose growers
use brown paper grocery bags to sweat their roses.
|

Alternate method "sweat" roses
using brown paper bag |
Place the bag upside down over the plant. Cut two slits in the
top and anchor the bottom with soil. After growth starts, the bag
can be removed slowly, first by increasing the size of the slits
and then taking the bag off all together. Sweating is only done
with newly planted bare-root roses. It is not done each spring.
Don't use plastic bags for sweating. Heat buildup can cause injury
or even death of the rose plant.
Potted Roses
Potted roses are the easiest to plant because you have a plant
that is already growing. Potted roses offer the flexibility of being
ready for planting throughout the growing season. With containers,
simply tip the pot on its side and tap the root ball out. If the
root ball doesn't come out easily, use a pair of tin snips, shears,
or knife to cut the container off. Set the root ball into the prepared
hole so the bud union is at the recommended depth. Refill the hole
with soil and water as with bare-root roses. In the case of potted
roses, you will not have to cover the canes with soil or sweat the
canes as this process has been done for you by the nurseryman.
|

Planting a potted rose bush |
Boxed Roses
Roses are sometimes offered for sale in cardboard boxes labeled
"plant them box and all." Experience shows that this practice
often discourages quick rooting and establishment of the plant.
There are two options for boxed roses. If the rose is planted in
the spring and is still dormant, simply take it out of the box and
treat it like a bare-root rose. If the plant has broken dormancy
and is growing, cut the bottom off the box and set the rose in the
hole at the proper depth. Then, cut through the sides of the box
and carefully peel the box away. Refill the hole with soil and water.
History |
Selecting Rose Plants | Site
Selection & Bed Preparation | Planting
| Water, Mulch & Fertilizer
| Winter Protection | Pruning
| Disease & Insect Pests
| Different Kinds of Roses | Selected
References | Societies &
Organizations | Mail Order
Sources | Video
Credits |